Enquiry:hkmarketing@epc.com.hk 
The DXG-Series of antennas are idealy suited to applications such as bridge deck inspection, utility mapping UXO remediation, archaeology or any application where high resolution GPR data needs to be acquired at all possible depths. Compatible with the GeoScope ™ Mk IV ultra-wideband step frequency GPR, the DXG antenna is available in 90cm, 1.2m and 1.8m widths, with other sizes available on a custom order basis. Designed to be compatible with the DX series of antennas, the DXG brings the advantages of a ground coupled solution into the 3d realm for the first time.
3d-Radar DX-Series antenna arrays allow scanning of up to 41 channels of GPR data over a continuous 200MHz to 3GHz frequency range. Near surface signal fidelity with the DX antenna is enhanced by orienting the transmitting and receiving antenna elements in opposite directions, minimizing antenna ringing while delivering high resolution imagery.
The air-coupled antenna design offers clear impulse response with low ringing and high suppression of the direct wave from transmitter to receiver. Operated with the GeoScope ™ Mk IV step-frequency radar, the DX-Series antennas offer a unique capability of collecting 3-dimensional GPR data with dense line spacing, allowing full 3-dimensional data processing. The antenna has support for multi-offset recording, and has a built in GPS receiver.
Ideal for applications such as high speed road/bridge deck inspection, network level utility mapping, railway ballast inspection and military uses, the DX Series of antennas are available in 1.8, 2.1, 2.4 and 3.3 meter widths. Other antenna sizes are possible.
